FUJITSU C150-E146-02EN User Manual
Page 67
6-4
Reading Mode Setting When the Video Interface Option is Installed
This section describes the button specifications and setup details for each of the simplex (front-side),
duplex (front-side) and duplex (back-side) reading modes when the scanner has the video interface
option in the third party .
When reading mode is set by the command from the host computer, the following button operation is
not required.
NOTE
When the video interface option is installed in the scanner, the scanner automatically recognizes the
board and changes the display.
At any time you press
, scanner returns to screen M1
1 Turn the power ON and verifty that
“Scanner Ready” is displayed on LCD.
2 Press
then the scanner displays
Screen M2.
3 Press
then the scanner displays
Screen 1.
4 Select ADF or FB by pressing
or
then press
. The scanner displays
Screen 2.
5 Select “Simplex” or “Duplex” by pressing
or
. Then press Enter. The scanner
displays Screen 3.
<Screen M1>
<Screen M2>
<Screen 1>
<Screen 2>