FUJITSU 8000 SERIES - Manual (Page 13)

3
1 Busy lamp
This lamp lights up while data is read from a CD-ROM or music CD is played.
2 Headphone volume (only for music CDs)
Use this control to adjust the volume of headphones.
3 Headphone jack (only for music CDs)
When listening to a music CD with a headphone, plug it to this jack.
4 Floppy disk access lamp
This lamp lights up while the floppy disk is accessed.
5 Ventholes (on the side panel and the bottom of the front panel)
These ventholes take air in for cooling inside.
6 Front access bay
Connect optional devices, such as an internal hard disk and a magneto-optical disk drive).
7 CD-ROM drive
Insert a CD-ROM into this drive to read data or programs, or insert a music CD for playback.
8 Hard disk access lamp
This lamp lights up while the hard disk is accessed.
9 Power lamp
This lamp lights up in green when the PC is on.
This lamp lights up in orange in the standby (power-saving) mode.
10 Power switch
Press this switch to turn on the PC or set the system to the standby (power-saving) mode.
11 Reset switch
Press this switch to delete data from the memory to re-load programs including OS.
12 Eject button
Press this button to insert or remove a CD-ROM.
13 Floppy disk eject button
Press this button to remove a floppy disk from the floppy disk drive.
Do not press this button when the floppy disk access lamp is on.
14 Floppy disk drive
Writes data to or read data from a floppy disk.
15 USB connector
Connect a USB peripheral device.
02-DP8 (01-07) 3/2/01, 2:31 PM 3