FUJITSU 8000 SERIES - Manual (Page 50)

40
Important
• When you do not install an additional memory module in BANK2, insert the continuity module
into it. When BANK2 has no module installed, the PC does not operate properly.
• The continuity module is not used on computers equipped with an additional memory module
in BANK2 as a custom-made option. Therefore, memory combinations using the C-RIMM
shown in the table cannot be chosen on such computers.
• Be sure to install memory modules of the same size to a combination of RIMM2 and RIMM3
and a combination of RIMM2 and RIMM4.
■ Installing/removing memory modules
Here, procedures for installing and removing memory modules are explained with an example of
replacement of the continuity module in RIMM1 with a memory module.
Point
• In installing or removing a continuity or memory module, hold the PC unit to prevent it from
falling. Work will be easier on a PC in a horizontal position.
• A front access bay with a device installed may prevent you from installing and removing memory
modules with ease. In that event, remove the PC cover after carrying out Step 3 in “Installing
memory modules” and then remove the screws from the front access bay to slide the device
toward the front of your PC.
• When returning the device back into the front access bay, use care not to allow it to touch the
memory modules.
06-DP8 (34-42) 3/2/01, 2:32 PM 40