FUJITSU 8000 SERIES - Manual (Page 79)

69
LAN controller
RAM for send/receive buffer
External interface
Transfer media
Transfer method
Access method
Security feature
Data transfer speeds
Wiring shape
Maximum segment length
Maximum number of nodes per segment
Intel 82550
3 KB each for sending and receiving
ISO8802-3 100BASE-TX/10BASE-T
Twisted pair cable *1 (100 Mbps: Category 5, 10
Mbps: Categories 3 to 5)
Base band
CSMA/CD
MD-5, SHA-1, DES, and 3DES
are hardware-supported
100 Mbps, 10 Mbps
Star shape
100 m
Depends on the hub unit *2
■ LAN adapter specifications
*1:To appropriately run the network at 100 Mbps, use a category 5 or higher unshielded twisted pair (UTP) cable. Data
may be lost if a category 3 or 4 cable is used.
*2:The “hub unit” refers to a 100BASE-TX/BASE-T concentrator.
Point
• The standard LAN of this PC automatically adapts to the speed of the connected network.
After the network speed is changed due to the replacement of hub units or other reasons, be
sure to use a cable of an appropriate data grade for the speed.
■ Sound specifications
Video controller
Display mode
Video output signal
Video memory
ATI Technologies RAGE TM 128UltraGL 4X
1600 x 1200 dots, 16.77 million colors max.
Video: Analog RGB, synchronous signal: TTL-
compatible
16 MB SGRAM
*1:Supports DirectX7.0a or later.
■ Graphical specifications
Sound controller
PCM record/playback feature
Analog input terminals
Analog output terminals
Intel 82801BA Chipset (built-in) + Analog
Device AD1885
48kHz sampling rate, max.
Line In (Stereo), Mic In (Mono)
Recommended load impedance for Line Out
(Stereo): 10 kiloohms, min.
*1:Supports DirectX7.0a or later.
11-DP8 (67-75) 3/2/01, 2:33 PM 69