FUJITSU 8000 SERIES - Manual (Page 63)

53
6 Connect flat cables.
• When connecting an IDE-compliant internal option
The connector of the secondary IDE cable, which is marked “To the motherboard” in the
figure below, is connected to the secondary IDE connector in the PC unit.
Connect components as follows to the master and slave connectors:
< Secondary IDE cable (40 pins)>
SLAVE MASTER
Pin 1 Red line
Connect the option here
to configure it as a slave. Connect the option here to
configure it as the master.
To the
motherboard
Master Slave
CD-ROM only CD-ROM —
Hard disk + CD-ROM Hard disk CD-ROM
Magneto-optical disk + CD-ROM Magneto-optical disk CD-ROM
08-DP8 (51-56) 3/2/01, 2:32 PM 53