FieldServer FS-8700-40 - Manual (Page 5)

FS-8700-40 SBT FSI Driver Manual Page 5 of 32
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
HARDWARE CONNECTIONS 3
3.1 Using the NIM-1R or NIM-1W for MXL
Configure the NIM-1R 3 or NIM-1W for Foreign System Interface (FSI) by setting all of the switches in SW2
to open (or OFF). See connection diagram below:
Connect the NIM-1R to an RS-232 port on the Fieldserver as depicted in the fiagram below (brown circle)
Connect the NIM-W to an RS-485 port on the FieldServer as depeicted in the diagram below.
FieldServer P1
1 8
2
3
4
1
6
7
8
5
10
11
12
9
14
15
16
13
TB4
G
n
d
_ + G
n
d
F
G
_ +
RS-485
Opto
Isolated
FS-8917-03
RJ45 to
DB9M
Connector
RJ45 CAT 5 Cable
FS8915-10
Cerberus Cable
P/N 555-193085
FS -8 91 7-0 3
NIM-1R
Connection
3 Note that NIM-1R is no longer supported by Siemens and is therefore considered to be legacy while NIM-1W is common.