Furuno FSV-84 - Manual (Page 18)

1-10
Attaching the CRT filter
1. Attach two spacers (5×2.5, supplied) with screws (M5
×10, supplied) to the location
shown below.
2. Screw two hood retainers (supplied) into the filter (supplied).
3. Set two washers (supplied) into the two hood retainers attached at step 2.
4. Attach the filter to the monitor unit as shown below.
Hood retainer (2 pcs.)
Washer (2 pcs.)
Filter
CRT
Spacer (2 pcs.)
Screw (2 pcs.)
M5
tapping hole
(Up side)
Notch
(Down side)
How to attach the hood