Safety instructions, Caution, Warning – Furuno FSV-84 User Manual

Page 3: Danger

Advertising
background image

i

WARNING

Do not install the equipment where it
may get wet from rain or water splash.

Water can cause fire or electrical shock, or
damage the equipment.

Be sure no water leaks in at the trans-
ducer installation site.

Water leakage can sink the vessel. Also
confirm that the transducer will not loosen
by ship's vibration. The installer of the
equipment is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility for
any damage associated with improper
installation.

Install the specified transducer tank
in accordance with the installation
instructions. If a different tank is to be
installed the shipyard is solely respon-
sible for its installation, and it should
be installed so the hull will not be
damaged if the tank strikes an object.

The tank or hull may be damaged if the
tank strikes an object.

DANGER

Keep away from raise/lower
shaft in hull unit when it is
moving.

Gears will cause serious injury.

WARNING

Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.

CAUTION

Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.

Warning, Caution

Mandatory Action

Prohibitive Action

SAFETY INSTRUCTIONS

The installer must read the safety instructions before attempting to install the equipment.

DANGER

Indicates a potentially hazardous situation which, if not avoided,
will result in death or serious injury.

WARNING

Do not open the equipment unless
totally familiar with electrical circuits
and service manual.

High voltage exists inside the equipment,
and a residual charge remains in capacitors
severalminutes after the power is turned off.
Improperhandling can result in electrical
shock.

Turn off power at the switchboard before
beginning the installation.

Electrical shock or fire can result if the
the power is left on.

Advertising