Furuno FSV-84 User Manual
Page 33
2-5
Housing Clamp Washer Nut
Center Pin Gasket
7.5
Shield
3
Positioning guide pins
Guide pins of the connector identify the mating receptacle. They are;
•
Guide pin A (Large): 4
•
Guide pin B (Small): 1
Use the tool (Type: 10-910-0179-0) shown below to position guide pins.
Guide Pin A (Large)
Connector
Guide Pin
CN-A303
Guide Pin B (Small)
4
1
Tool
Guide pin insertion tool (notch in head)
Assembling BNC connector (CN-A304 to CN-A 308)
1. Remove vinyl sheath of the cable by 7.5 mm.
2. Pass the cable through the nut, washer, gasket and
clamp.
3. Unravel the shield and fold it back onto the clamp.
4. Remove the insulator, leaving 3 mm.
5. Trim the shield as shown in the drawing. Solder the
center chip to the conductor of the cable.
6. Pass the cable through the housing and tighten the
nut.