2 power cable, 3 cable from monitor unit, 4 cable from control unit – Furuno FSV-84 User Manual
Page 38
2-10
Positioning guide pins
Guide pins of the connector identify the mating receptacle. They are;
•
Guide pin A (Large): 1
•
Guide pin B (Small): 1
Use the tool (Type: 10-910-0179-0) shown below to position guide pins.
Guide Pin A (Large)
Connector
Guide Pin
CN-A101
Guide Pin B (Small)
4
1
Tool
Guide pin insertion tool (notch in head)
2.4.2 Power
cable
Attach the NCS-253-P connector to the power cable (DPYCY-1.5 or equivalent) and connect
to the CN-A110 on the rear of the processor unit.
Conductor
S = 1.5 mm
2
φ
= 1.56 mm
Vinyl
sheath
Armor
Cable DPYCY-1.5
Armor
Vinyl sheath
Taping
Solder lead wire to armor and
connect it to #1 pin of connector.
Use cable DPYCY-1.5
(Japan standard cable)
or equivalent cable.
Slip on heat-shrink tubing
or elastic tubing and heat.
Armor
Vinyl sheath
Taping
Solder lead wire to armor and
connect it to #1 pin of connector.
#2
#3
#1
Assembling connector NCS-253-P
2.4.3 Cable from monitor unit
Connect the cable 10S2074 (10 m) or 10S2075 (30 m) from the monitor unit to the
connectors in the processor unit as shown below.
38P connector: CN-A103 (For the optional sub-monitor display, CN-A108)
D-sub 25 pin:
CN-A102 (For the optional sub-monitor display, CN-A107)
D-sub 15 pin:
CN-A104 (For the optional sub-monitor display, CN-A109)
2.4.4 Cable from control unit
For blackbox configuration, attach the cable (10S2076) from the control unit (FSV-8401) to
CN-A103 on CONE Board (10P6905) in the processor unit, passing it through the cable
clamp in the processor unit.