FUJITSU PCI Gigabit Ethernet 4.1 Update 2/ 5.0 for Oracle Solaris C120-E276-11ENZ0(A) - Manual (Page 49)

Note
- For more information about the dladm(1M) command, please refer to the "System Administration Guide: IP Services" and the "man
pages section 1M: System Administration Commands" of Oracle Documentation.
4.2.1.1 Create a LinkAggregation (dladm create-aggr)
This section explains the dladm create-aggr command for activating LinkAggregation.
- Synopsis
- Solaris 10 8/07 or later
/usr/sbin/dladm create-aggr -d dev [-d dev] ... key
-d dev: Specify the name of the physical interface (including instance number) belonging to
a LinkAggregation Group (*1)
You can specify one to 255 devices.
key: Specify the key number to identify the LinkAggregation
Specify a number ranging from 1 to 999.
*1: The group means an aggregate unit of the interfaces to distribute, to collect and to make mutually redundant.
- Solaris 11
/usr/sbin/dladm create-aggr -l ether-link [-l ether-link...] aggr-link
-l ether-link: Specify the name of the physical interface (including instance number)
belonging to a LinkAggregation Group (*2)
You can specify one to 255 devices.
aggr-link: The name of the representative interface.The name of the representative interface.
*2: The group means an aggregate unit of the interfaces to distribute, to collect and to make mutually redundant.
- Description
Creates a LinkAggregation Group.
- Exit Code
0: normal end.
>0: abnormal end.
- Example
Processes to create and activate a LinkAggregation Group are shown below.
- 43 -