FUJITSU PCI Gigabit Ethernet 4.1 Update 2/ 5.0 for Oracle Solaris C120-E276-11ENZ0(A) - Manual (Page 55)

passive: passive mode
off: off mode
-T time: Specify the LACP timer
short: every one second
long: every 30 seconds
aggr-link: The name of the representative interface.
- Description
Modifies a LinkAggregation Group.
- Exit Code
0: normal end.
>0: abnormal end.
- Example
Processes to modify the policy of a LinkAggregation Group are shown below.
- Solaris 10 8/07 or later
- The following example shows how to change the "key=1" LinkAggregation Group to "policy=L2":
# /usr/sbin/dladm modify-aggr -P L2 1
- Solaris 11
- The following example shows how to change the "aggr-link=aggr1" LinkAggregation Group to "policy=L2":
# /usr/sbin/dladm modify-aggr -P L2 aggr1
Processes to modify the LACP mode and LACP timer of a LinkAggregation Group are shown below.
- Solaris 10 8/07 or later
- The following example shows how to change the "key=1" LinkAggregation Group to "LACP mode=active, LACP timer=short":
# /usr/sbin/dladm modify-aggr -l active -T short 1
- Solaris 11
- The following example shows how to change the "aggr-link=aggr1" LinkAggregation Group to "LACP mode=active, LACP
timer=short":
# /usr/sbin/dladm modify-aggr -L active -T short aggr1
Note
- It is not necessary to use this command if the desired policies are L4 distribution, LACP mode off, and LACP timer 'short'.
LinkAggregation Groups are created with these default values.
- After rebooting the system, the LinkAggregation settings remain effective.
- For more information about this command, please refer to the "man pages section 1M: System Administration Commands" of Oracle
Documentation.
- 49 -