FUJITSU PCI Gigabit Ethernet 4.1 Update 2/ 5.0 for Oracle Solaris C120-E276-11ENZ0(A) - Manual (Page 77)

- When a VLAN interface is used in Exclusive-IP Non-Global Zones, please add a VLAN interface of the fjgi interface to the Exclusive-
IP Non-Global Zones in the Global Zone, and then make the VLAN interface active using the ifconfig(1M) command in the Exclusive-
IP Non-Global Zones.
Example: Adding fjgi1002 to an Exclusive-IP Non-Global Zone (zone2).
- Solaris 10 8/07 or later
1. Execute the following commands in the Global Zone.
# ifconfig fjgi1002 plumb
# zonecfg -z zone2
zonecfg:zone2> set ip-type=exclusive
zonecfg:zone2> add net
zonecfg:zone2:net> set physical=fjgi1002
zonecfg:zone2:net> end
zonecfg:zone2> exit
(Note) Reboot the Exclusive-IP Non-Global Zone to make this setting effective.
If the Exclusive-IP Non-Global Zone has not booted, execute the following command.
# zoneadm -z zonename boot
If the Exclusive-IP Non-Global Zone has booted, execute the following command.
# zoneadm -z zonename reboot
2. Execute the following command in the Exclusive-IP Non-Global Zone.
# ifconfig fjgi1002 plumb 192.168.170.1 up
- Solaris 11
1. Execute the following commands in the Global Zone.
# dladm create-vlan -l net4 -v 1
# zonecfg -z zone2
zonecfg:zone2> set ip-type=exclusive
zonecfg:zone2> add net
zonecfg:zone2:net> set physical=net1004
zonecfg:zone2:net> end
zonecfg:zone2> exit
(Note1) net4 is the vanity name of fjgi2.
(Note2) Reboot the Exclusive-IP Non-Global Zone to make this setting effective.
If the Exclusive-IP Non-Global Zone has not booted, execute the following command.
# zoneadm -z zonename boot
If the Exclusive-IP Non-Global Zone has booted, execute the following command.
# zoneadm -z zonename reboot
2. Execute the following command in the Exclusive-IP Non-Global Zone.
# ifconfig net1004 plumb 192.168.170.1 up
- When a LinkAggregation is used in Exclusive-IP Non-Global Zones, please make the LinkAggregation Group in the Global Zone
with the creation procedure in "
Chapter 4 LinkAggregation Feature ". Also add the representative LinkAggregation interface to the
Exclusive-IP Non-Global Zones, and then make the representative LinkAggregation interface active using the ifconfig(1M) command
in the Exclusive-IP Non-Global Zones.
- Solaris 10 8/07 or later
Example: Adding aggr2 which is a LinkAggregation Group with fjgi0, fjgi1, fjgi2 and key=2 to an Exclusive-IP Non-Global Zone
(zone2).
- 71 -