FUJITSU M3000 - Manual (Page 41)

Chapter 3 Installing the Server 3-7
Note – Use the administration console that has been connected as described in
Section 3.3.3, “Connecting the Administration Console” on page 3-4 for XSCF Shell
operations.
■ Section 3.4.1, “Logging in to the XSCF Shell” on page 3-7
■ Section 3.4.2, “Initializing the XSCF Unit” on page 3-9
3.4.1 Logging in to the XSCF Shell
To initialize the XSCF settings, use the XSCF default user account. Until the user’s
accounts for the user environment are registered, log in with the default user
account according to the authentication method. The privileges of the default user
are useradm and platadm.
Log in to the XSCF Shell with this procedure:
1. Set the key in the operator panel to the Service position.
The key for the operator panel is supplied with the server.
The Service position is indicated by the wrench symbol. The Locked position is
indicated by the lock symbol.
FIGURE 3-3 Mode Switch on the Operator Panel
For details on the operator panel, refer to Section A.2, “Operator Panel Overview”
on page A-4 .
2. Turn the AC power source circuit breaker to ON.
The server starts the XSCF initialization. That can take 5 minutes.
Locked
Service