FUJITSU M3000 - Manual (Page 45)

Chapter 3 Installing the Server 3-11
10. Connect the system control network to a LAN port on the XSCF unit with an
Ethernet cable.
The system control network has one or more administrative consoles used to
monitor the network. This connection will replace the temporary connection
made between the administration console and the serial port on the XSCF unit.
For an outline of the network connection, refer to
FIGURE 4-1 .
Note – The LAN ports on the XSCF unit conform to IEEE 802.3i and IEEE 802.3u.
However, only the auto negotiation mode can be used for negotiation. The fixed
mode cannot be used.
3.5.1 Verifying the Configuration
Verify the hardware configuration by following this procedure on the administration
console connected to the system control network.
1. Log in to the server, and access the XSCF Shell.
For details, refer to the SPARC Enterprise M3000/M4000/M5000/M8000/M9000 Servers
XSCF User’s Guide.
2. From the XSCF Shell, type the showhardconf command.
All the components installed in the server and their statuses are displayed. For
details on how to use the showhardconf command and an output example, refer to
Section B.3.1, “Using the showhardconf Command” on page B-4 .
3. Confirm that no asterisk (*) is displayed in front of any FRUs.
4. From the XSCF Shell, type the showhardconf command with the -u option.
5. Check the number of FRUs mounted on the server against the product test
record.
For an output example of showhardconf -u, refer to Section B.3.1.1,
“showhardconf -u Command” on page B-6 .
6. From the XSCF Shell, type the console command with the -d 0 option.
This switches you from the XSCF console back to the domain console (OS console)
and displays the ok prompt.
XSCF> console -d 0
Connect to DomainID 0?[y|n] :y
ok