Frymaster H17 - Manual (Page 10)

1-6
1.6 Replace Heating Element
1. Perform Procedure 1.5, Replace Temperature Probe, Steps 1-7.
2. Remove the element wires from the
connector. Press down on either side of the
connector while pulling up on the top portion.
The connector will open from the top. Pull
all wires from the connector.
3. Remove the screws securing the temperature
probe bracket from the element. Remove the
probe clamp (metal wire-wrap). Set the
temperature probe and probe-securing
components aside.
4. Disconnect the element springs.
Top Portion
Harness
Connector
Closed
Harness
Connector
Open
Push in on tabs to release
top portion
Remove probe clamp (metal wire-wrap), and screws
securing probe bracket to element.
Disconnect element springs here