GSI Outdoors PNEG-951 - Manual (Page 20)

20 PNEG-951
This switch activates the moisture control circuit. It lights up when the grain column temperature is below the
moisture control (grain temperature) set point.
The dryers outside service light is turned on or off here. It also may be set on auto, which turns the light on while
the dryer is running and off if a shutdown occurs.
This switch starts and operates the dryer based on switch settings. If other switch settings are in the off position,
individual dryer components can be operated by turning the drying mode switch to continuous flow, pressing the
dryer power run button and then turning on the desired dryer component.
This switch stops all dryer functions. If an automatic dryer shutdown occurs, first determine and correct the cause
of the shutdown. Then, press the dryer power stop button to reset the dryer before restarting.
MOISTURE CONTROL SWITCH
OUTSIDE LIGHT SWITCH
RUN SWITCH
STOP SWITCH
KEYPAD LAYOUT
All of the timer settings, delays and operational dryer parameters are setup with the keypad.
Listed below is a description of the buttons used on the keypad.
RESET BUTTON
On this screen is information on the version of software that is installed on your dryer.
Press the button to intialize the dryer. The computer will run a series of tests on its internal
components. The dryer controls will not operate until this button has been pressed.