GSI Outdoors PNEG-951 - Manual (Page 72)

72 PNEG-951
SELECT DRYER ADDRESS
This feature is used for networking several portable grain dryers together for monitoring on a PC with special
software. Changing this value will have no effect on the operation of the dryer, only the monitoring software
(Watchdog 2000).
ATTEMPT TO REFILL
Changing this setting to yes allows your dryer to pause its drying process in the event that the Out of Grain Timer
has expired. Instead of the dryer shutting down with a Out of Grain error message, the following sequence of
events will happen:
· Load will continue to run
· Fan will continue to run
· Burner will stop drying
· Unload will stop
The dryer will continue in this mode until the fill switch (paddle switch on the load auger) has changed its state to
indicate the dryer is full of grain again. At this point the dryer will:
· Load will stop running
· Burner will purge and relight to continue drying
· Unload will start discharging grain again
· Out of Grain timer will reset
MODEL NUMBER
This screen tells the computer in your Network dryer what model of dryer it is. Do not change any information in
this screen unless you are
directed to either by a GSI service technician or engineer.
Just press the button to advance to the number on the line that needs to be changed or you can use
th e button toback up to the previous number on the line.
Use the to change the number directly above the cursor “^”. Once you are satisfied with your.