Changing the battery – GE 27951 User Manual
Page 44
Memory Full
When answering system memory is full, the system answers after
10 rings, announces “
Memory full” and waits for you to enter
-digit security code. If you don’t enter the security code within 7
seconds , the phone hangs up.
You should erase some messages so the answering system can
record new messages.
NOTE: The unit also answers after the 10th ring if it is
turned off. To access the answering system, enter your 3-
digit security code.
Leaving a Memo
This feature lets you record a memo up to minutes long to store
as an incoming message.
1. Press and hold the
MEMO button
. Begin speaking after it announces “
Record message”.
. Release the
MEMO button when finished.
Changing the Battery
CAUTION: To reduce the risk of fire or personal
injury, use only the Thomson Inc. approved Nickel-
metal Hydride (Ni-MH) battery model 5-2734, that is
compatible with this unit.
1. Make sure the telephone is
OFF (not in TALK mode) before you
replace battery.
. Remove the battery compartment door.
. Disconnect the battery plug from the jack inside the battery
compartment and remove the battery pack from the handset.
. Insert the new battery pack and connect the cord to the jack
inside the battery compartment.