GE MULTILINK ML2400 - Manual (Page 169)

CHAPTER 10: VLAN VLAN
MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL 10–5
start vlan=<name|number|list|range>
To save VLAN configuration:
save
To edit VLANs:
edit id=<vlan Id> [name=<vlan name>] port=<number|list|range>
To display the VLAN information:
show vlan type=<port|tag> [<id=vlanid>]
The following command sequence shows how to configure VLANs on a MultiLink switch.
ML2400# vlan type=port
ML2400(port-vlan)## add id=2 name=test port=1-10
ML2400(port-vlan)## start vlan=all
ML2400(port-vlan)## save
Saving current configuration...
Configuration saved
To move Management Control on any VLAN:
add id=<vlan Id> [name=<vlan name>] port=<number|list|range>
[Forbid=<number|list|range>][<mgt|nomgt>]
To enable or disable Management Control on any VLAN:
edit id=<vlan Id>[name=<vlan name>][port=<number|list|range>[<mgt|nomgt>]