GE MULTILINK ML2400 - Manual (Page 294)

17–22 MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
MISCELLANEOUS COMMANDS CHAPTER 17: MISCELLANEOUS COMMANDS
• clear-stats
• portaccess
• reauth
• setport
• show-port
• show-stats
• trigger-reauth
The device commands are shown below.
• device
• backpressure
• broadcast-protect : enables or disables broadcast storm protection globally
• flowcontrol
• rate-threshold : sets the broadcast rate threshold (frames/sec)
• setage : sets the mgtagetime
• setport : sets the port configuration
The VLAN registration over GARP (GVRP) commands are shown below. Refer to VLAN
Registration over GARP on page 11–1 for details.
• gvrp
• help gvrp : configures GVRP parameters for dynamic VLAN
• set-forbid : sets forbidden ports for a tag-based VLAN
• show-ports : show ports current GVRP state
• show-forbid : show forbidden ports for tag-based VLAN
• set-ports : set GVRP port state usage
• show-vlan : shows dynamic/static tag-based VLANs
• static : convert dynamic VLAN to static VLAN
The IGMP commands are shown below. Refer to IGMP on page 15–1 for additional details.
• mcast
• set-leave : enables or disables IGMP immediate leave status
• set-port : sets the port mode
• set-qi : sets the query interval (60 to 127) for router ports
• set-qri
• set-querier : enables or disables switch as querier
• show-group : displays IGMP group list
• show-port : displays IGMP port mode
• show-router : displays IGMP router list
The Link Aggregation Control Protocol (LACP) commands are shown below.
• lacp
• add port
• del port
• edit port