GE 45608 - Manual (Page 17)

17
5. The remote displays SELECT THE KEY TO LEARN TO. All keys
except SET, Z-Wave, OK, or Arrows (scroll left & scroll right)
are available for learning. Press the key you want to teach the
command to.
6. The remote displays WHEN BACKLIGHT TURNS OFF PUSH
TEACHING KEY. The backlight turns off. The display reads
LEARNING NOW! PRESS TEACHING KEY. Press the teaching
key on the original remote control.
7. If Learning is successful, then display and backlight turn back
on. The remote displays SUCCESS! PUSH OK TO LEARN PUSH
SET TO EXIT.
8. Press OK to learn another key or press SET to exit Learning
mode. If you press OK, the remote returns to step 5 above and
is ready to learn another key.
NOTE: If learning fails, the display reads LEARNING FAILED PUSH
OK TO LEARN PUSH SET TO EXIT.
Possible causes for learning failure:
• Your remotes are too close to a UV source (i.e. in sun light,
or close to fluorescent lighting)
• Your remotes are too far apart.
• The teaching remote is an RF (radio frequency) remote.
Teaching remotes must be IR (infrared).
• The remotes’ IR LEDs are not aligned.
• Batteries in one or both remotes may not have a sufficient
charge
Deleting All Learned Keys
To delete all learned keys for a selected device, perform the
steps below:
1. From ADD LEARN KEY use the ARROW keys to scroll to DELETE
LEARN KEY. Press OK.
2. The remote displays SELECT MODE THEN PUSH OK. The
device name is displayed on the bottom line of the display
(for example, TV). Use the ARROW keys to cycle through the
available device types. Press OK.
3. The remote displays SELECT KEY TO DELETE OR PUSH OK TO
DELETE ALL.
4. Press OK. The remote displays DELETING ALL PUSH OK TO
CONFIRM.
5. Press OK. The remote displays ALL LEARNED KEYS DELETED.
PUSH OK TO DELETE MORE.
6. Press SET to exit