GE 45608 - Manual (Page 29)

29
6. When the screen displays SUCCESSFUL, the device has been
deleted from your network and reset to its factory defaults.
Groups
You can create a collection of devices (lights / nodes) that you can
turn On or Off as a group. You can create up to a maximum of 18
groups. A group can contain up to 232 devices.
Create a Group or Add a Device to a Group
1. Enter Z-Wave setup mode and highlight GROUP SETUP
2. Press OK; the screen will display ADD
3. Press OK; the screen will display SEL DIGIT
4. Press a digit (1-9) for the group you wish to add the device to.
Press SHIFT and the digit (1-9) if you are adding a device to
groups 10 through 18. The screen will display the group
you’ve chosen.
5. Press OK; the letter “W” will be displayed in the upper left hand
corner and the Z-Wave light will begin blinking indicating the
remote is waiting to connect to your device.
6. Press the button on the device so that it communicates with
the remote.
7. When the screen displays SUCCESSFUL you have successfully
added the Node/Light to a group.
8. To add additional Node/Lights to your group repeat steps 1
thru 10.
To control a Group:
1. When in Z-Wave mode press the GROUP key once to put the
remote into “GROUP Control” mode.
2. Press the digit key for the group you wish to control (1-9).
Press SHIFT and the digit (1-9) if you are controlling groups 10
through 18. The screen will display the selected Group.
• To turn a GROUP on, press and release the CH + key for
less than one second. The screen will display ON above the
selected GROUP.
Group Setup
Add Remove Delete Label