GE 45608 - Manual (Page 37)

37
Adding a Thermostat:
1. Enter Z-Wave setup mode and highlight THERMOSTAT
2. Press OK and the screen will display ADD
3. Press OK and the screen will display SETUP WAITING
4. Press the button on the thermostat’s Z-Wave interface
5. When the screen displays SUCCESS, you have successfully
added the THERMOSTAT to your remote control.
Controlling a Thermostat:
The features and functions that can be controlled vary by
manufacturer and you will need to review the user manual that
was provided to determine capabilities of your THERMOSTAT.
If supported by the thermostat, the 45608 LCD remote allows you
to check room temperature, adjust HVAC system modes (Heat,
Cool, Auto, Fan, etc.) and adjust temperature settings (SETPOINT).
Note: Your HVAC system may have to be set to “HEAT or
“COOL’” mode in order to remotely check and/or adjust the room
temperature. “AUTO” mode may not provide this function.
Deleting a Thermostat:
1. Enter Z-Wave setup mode and highlight THERMOSTAT
2. Press OK and the screen will display ADD
3. Use either ARROW keys to scroll until the screen displays
DELETE
4. Press OK and the screen will display SETUP WAITING
5. Press the button on the thermostat’s Z-Wave interface
6. When the screen displays SUCCESSFUL, you have successfully
deleted the thermostat.
Advanced Configuration
Some Z-Wave devices provide advanced
capabilities available only through the use of a
remote control like the GE 45608. One example is
the GE 45606 in-wall dimmer which allows the
end user to change whether the LED is illuminated
when the light is On or when the light is Off.
Please refer to the instructions of your Z-Wave
device for available options and specific
instructions on changing its advanced
configuration. Adv. Config.
Parameter
Number of
Bytes
Configuration
Value