GE 45608 - Manual (Page 28)

28
Turning a Light On or Off
• To turn a light on, press and release the CH + key for less than
one second. The screen will display ON above the selected
Light/Node.
• To turn a light off, press and release the CH - key for less than
one second. The screen will display OFF above the selected
Light/Node.
Setting a Light’s Brightness Level
• To brighten a light, press and hold the VOL + key for more than
one second. The screen will display BRIGHT UP above the
selected Light/Node. The light will continue to grow brighter
until the key is released.
• To dim a light, press and hold the VOL - key for more than one
second. The screen will display BRIGHT DOWN above the
selected Light/Node. The light will continue to grow dimmer
until the key is released.
Removing an Individual Device (Node / Light) From Your Remote
This only removes individual number key control. The device is still
part of your home control network and can be controlled through
the GROUP, SCENE and ALL commands.
1. Enter Z-Wave setup mode and highlight LIGHT SETUP
2. Press OK; the screen will display ADD
3. Press the right arrow key once; the screen will display REMOVE
4. Press OK; the screen will display SEL DIGIT
5. Press a digit (1-9) for the device location you wish to remove.
Press SHIFT and the digit (1-9) if you are removing devices 10
through 18. The screen will display the number you’ve chosen.
6. Press OK. When the screen displays SUCCESSFUL, the device
has been removed from the number key.
Deleting a Device (Node / Light) From Your Network
This completely removes the device from your home control
network and resets the device to its factory default settings.
1. Enter Z-Wave setup mode and highlight LIGHT SETUP
2. Press OK; the screen will display ADD
3. Press the right arrow key twice; the screen will display DELETE
4. Press OK; the letter “W” will be displayed in the upper left hand
corner and the Z-Wave light will begin blinking indicating the
remote is waiting to delete your device.
5. Press the button on the device so that it communicates with
the remote.