Graham Field ALTADYNE 765000 - Manual (Page 15)

765000-INS-LAB-RevB10 15
OPERATION
GETTING STARTED
1. Turn the main power switch
to the ON position.
2. Press the front panel power
button. The power indicator
will illuminate.
Note: The mattress system will
automatically enter maxfirm mode for the quickest inflation
at set-up; when inflated, it will then automatically enter auto-
adjust mode to select the appropriate pressure.
3. The pump will begin delivering air into the mattress.
The low pressure indicator and the maxfirm indicator
will illuminate for approximately twenty minutes until
the mattress is fully inflated.
4. Upon inflation, the system will automatically enter auto-
adjust mode to automatically select the appropriate
pressure according to the patient's weight. The auto-
adjust indicator LEDs will flash from left to right, and
the system will cycle through inflation and deflation,
until the Ready LED illuminates to show the process is
complete, and the mattress system automatically en-
ters alternate therapy mode.
5. Replace all sheets, blankets, and pillows on the bed.
6. You can now adjust therapy modes or tuning. Please see
earlier section, PUMP: FRONT PANEL, for a complete de-
scription of available adjustments, buttons and indicators.
QUICK DISCONNECT
Pull the power plug from the wall connector to disconnect
the device quickly.
main
power
switch
power button