GBC Titan 1244WF - Manual (Page 19)

GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 19
Display Control Panel-Continued
The Temperature displayed in the area
referred to as TOP TEMPERATURE and
BOTTOM TEMPERATURE is the value
that the laminator is attempting to attain.
Pressing the MEASURE button will
momentarily display the actual roller
temperature.
The current speed and job settings are given
on the right side of the display.
The current state of the heat rollers is given
on the lower portion of the display. The unit
will always be in one of three states:
AUTO-OFF, READY, or WAIT.
Auto-Off
In the AUTO-OFF state (also referred to as
Standby) the unit will no longer continue to
heat the main rollers. The unit will go into
this state after a period of inactivity or by
pressing the STAND-BY key. Press the
STAND-BY key to bring the unit out of
AUTO-OFF mode. See Fig. A
Ready
The READY icon will flash when the actual
roller temperature is nearing but not quite
met the target temperature.
The READY icon will be displayed
continually when the actual roller
temperature is within +/- 15* F of the target
temperature entered by the operator. See
Fig. B
Wait
The WAIT icon is displayed when the
actual roller temperature is much higher or
lower than the target temperature entered by
the user. See Fig. C
Fig. A
Fig. B
Fig. C