GBC Titan 1244WF - Manual (Page 27)

GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 27
Webbing Thermal Film Using Threading Card
CAUTION: The laminator rollers will be hot and
can burn you. For pressure sensitive film (PSA),
refer to the section titled
WEBBING: USING FILM THREADING CARD FOR
PSA FILM.
1. Turn the Main Power ON /OFF to On.
2. Set top and bottom temperature with regards to the
film type used.
3. Ensure no brake tension is applied to the film shafts.
4. Pull the top roll film down under the upper idler bar
and allow to drape over the top heat roller (Fig. 3)
5. Pull the lower film behind the lower idler bar, Lower
the table Pull Film up towards the film draped over the
top heat roller and adhere the Lower Film to the upper
Film (Fig. 4).
6. Pivot the table back to its feeding position while
ensuring the threading card is on top of the feed table
(Fig. 5).
7. Use a threading card to push the two materials into the
heat roller nip.
8. Lower the main roller to initial contact with the
threading card.
9. Ensure forward is selected for Motor direction and
Press the Foot Switch
10.From the rear of the machine, guide the web over the
chill idler, if installed, and through the pull rollers.
11.Once the web has entered the pull roller nip, lower the
pull roller nip. Adjust unwind film tension; use as little
tension as possible to get smooth output.
12.Once the threading card has completely exited the pull
rollers, press the stop button.
13.Now refer to the section entitled START
LAMINATING.
Fig.3
Fig. 4
Fig. 5
THERMAL
LAMINATE
THERMAL
LAMINATE
THERMAL
LAMINATE
THERMAL
LAMINATE
THERMAL
LAMINATE