GBC Titan 1244WF - Manual (Page 28)

GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 28
Fig. 6
Fig. 7
Fig.8
Webbing PSA Film/Mount Adhesive Using Threading
Card
The laminator should be cool to the touch before
Proceeding.
1. Turn the Power ON /OFF to On
2. Load the rolls of film as illustrated in (Fig. 6). Ensure
no brake tension is applied to the film shafts.
3. Pull the top roll of film down under the idler bar and
up to the upper front rewind tube.
4. Place one piece of masking tape in the center of the
film and secure to the rewind tube.
5. Make two full wraps around the rewind tube, and then
score the laminate without cutting the release liner.
Pull the laminate down allowing it to drape over the
upper roller (Fig. 6).
6. Pull the mount adhesive up towards the film draped
over the upper heat roller (Fig.7).
7. Stick the mount adhesive to the exposed adhesive of
the upper role.
8. Insert the table back to its feeding position while
ensuring the threading card is on top of the feed table
(Fig. 8).
9. Use a threading card to push the two materials through
the heat roller nip
10.Lower the main heated roller to bring the main roller
into initial contact with the threading card. Ensure
front is selected and press the foot switch.
11.From the rear of the machine, guide the web over the
chill idler, if installed, and through the pull rollers.
Once the web has entered the pull roller nip, close the
pull roller nip –
12.Press the stop button when the threading card has
completely exited the pull rollers and adjusts the film
web tension using as little tension as possible.
13.Now refer to the section titled START
LAMINATING.
REWIND TUBE
Adhesive
Mount
Film
PSA
HEAT ROLLER
CHILLED ROLLER
Adhesive
Mount
Film
PSA