GBC Titan 1244WF - Manual (Page 31)

GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 31
To Unweb the laminator
Unweb the laminator if you are changing film widths,
cleaning the rollers or have finished using the machine for
the day.
CAUTION: Do not cut yourself
1. Using a slitter, cut (1) the output from the web (Fig.
13).
2. Cut (2) remaining top film web between the idler bar
and heat roller. PSA film cut the release liner too.
3. Cut (3) the film web between the lower film supply
and the idler bar (Fig. 13).
CAUTION: Be careful not to cut any of the rollers!
4. Remove the feed table.
5. Gap the main rollers and pull rollers.
6. Carefully grab hold of the web (top and bottom film),
from the back operating position and pull towards you
(Fig. 14).
7. Do not allow the adhesive side of the film to contact
the heat or pull rollers.
Clearing a Film Jam (Wrap-up)
Film jams (wrap-ups) may occur if the film is loaded
backwards or if the area at which film exits the equipment
is blocked. The film, when jammed, wraps around the heat
rollers or pulls rollers during webbing if webbing, if a
Thread Card is not used.
To clear a jam:
1. Immediately stop the laminator by pressing STOP.
2. Set motor direction to rear.
3. Use the footswitch to reverse the web until the wrap up
is clear.
4. Raise the main roller and pull rollers.
5. Manually guide the web from the main rollers and pull
rollers.
6. Once the film jam has been cleared, lower the main
roller and pull rollers.
7. Refer to the section titled START LAMINATING.
Fig. 13
Fig.14
PULL WEB
(1)
.......a PSA film or mount adhesive
(3)
(2)
(2)