GBC Titan 1244WF - Manual (Page 25)

GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 25
In-Line Slitters
The In-Line Slitters allows the operator to
slit the images as they pass through the Main
Rollers and into the Pull Rollers. The
trimmed waste can then be attached to the
Rewinder Tubes and disposed of later.
To engage the In-Line Slitters, simply press
the lever down to expose the blade. Keep
hands and fingers away from the path of the
In-Line Slitters. The blade is extremely
sharp and can cut you.
To disengage the In-Line Slitter blade,
simply push the blade lever up to return the
blade to its original state.
Rear Cut-Off Blade
The Rear Cut-Off Blade is intended to cut
the web output from the laminator and
should not be used for any other purposes.
Stop the laminator before using the Rear
Cut-Off Blade. Moving material can
damage the Rear Cut-Off Blade.
Keep hands and fingers away from the path
of the Rear Cut-Off Blade. The blade is
very sharp and can cut you.
Slide the rear Cut-Off Blade about six inches
into the web. Press and hold down the blade
engage lever. Slide the Rear Cut-Off Blade
from one side to the opposite side then
release.