GBC Titan 1244WF - Manual (Page 23)

GBC 1264WF/1244WF Operation Manual
© 2006 General Binding Corporation Page 23
Loading Film Continued
The core chucks need to be adjusted to
match the width of the film that is going to
be loaded on the laminator. To do this, be
gin by removing the rubber o-rings.
Then use the included hex tool to loosen the
setscrews in the core chucks. Note: Do not
remove the setscrews; they only need to
be loosened.
Make the necessary adjustments to the upper
roll of laminate to center it to the Main
Rollers.
Slide the Core Chucks into place and gently
tighten the setscrews to secure the Core
Chuck. The rubber O-Rings can be replaced
to keep the film from moving off center.
Make the necessary adjustments to the lower
roll of laminate to match up with the upper.
Lock the Core Chucks into position and
replace the O-Rings.