GE ZV800 - Manual (Page 15)

15
Installation Instructions
INSTALL MOUNTING BRACKET
This vent hood must be secured to the horizontal
support or wall studs.
• With the template taped in place, use a punch to
mark all mounting screw locations.
• Drill 1/8” pilot holes at the 6 punched locations.
• Remove the template.
• The 2 holes in the support bracket holes must enter
studs or the horizontal support.
• Use wood screws to secure the mounting bracket to
the wall. The screws must engage wall studs or the
installed horizontal mounting support.
• Check to be sure that the bracket is level.
There is no way to level the hood after hanging
it from this bracket.
2
WALL-MOUNTED INSTALLATION—RECIRCULATING
PREPARE THE HOOD
• Remove the hood from the box. Remove packaging
and tape.
• Remove one screw on each side of the cover on the
electrical panel. Lift off the cover and set aside with
screws.
• Stand the electrical panel upright.
• Align the screw holes in the bottom of the panel with
the holes on the base of the hood at the front side.
• Install 3 screws provided.
• Snap the damper into the
exhaust outlet on the top of
the hood.
3
Remove 2 side
cover screws
Install
damper
Electrical
panel
Secure
electrical panel
with 3 screws
Junction box
Inside screw