GE ZV800 - Manual (Page 22)

22
Installation Instructions
UNDER-CABINET INSTALLATION
COMPLETE THE INSTALLATION
AND CONNECT DUCTWORK
• Drive 2 screws into each side bracket.
Be sure the screws engage the filler blocks
or the cabinet bottom.
• Pull the glass canopy forward to access and install
2 screws through the hood and into the brackets on
both sides.
• Use duct tape to secure the duct to the exhaust
outlet in the top of the hood. Do not use screws
at this location.
If there is a noticeable gap between the hood and the
bottom of the cabinet on the sides:
• Slide canopy forward and install original top screws
through the bottom of the hood and into cabinet
bottom or frame.
NOTE: Install wood filler blocks if necessary to
accept the screws.
7
Install 2 Screws into
Each Side Bracket
MOUNT THE HOOD
• Carefully, lift the hood into the cabinet. Guide the
hood upwards to meet the ductwork.
IMPORTANT: One person must hold the hood in place
while the other drives the screws into the mounting
frame.
6
Install original top screws
Install a wood screw
on each side of the
mounting frame