Installation instructions, Important, Utility closet connection locations – GE AZ85H12DAC User Manual
Page 16: Reference dimensions
Installation Instructions
16
UTILITY CLOSET CONNECTION LOCATIONS
IMPORTANT:
Plan and locate plenum, wall plug, drains and
thermostat carefully to avoid interference. Hard-to-reach locations
will make installation and service difficult!
Reference Dimensions
A Thermostat cable: 9
1
⁄
2
” long
B Power cord: 60” long
C Case width and depth: 23
1
⁄
8
”
D Case height: 31”
E Condensate drains: 3/4” connector
• Primary Drain – Centerline of cutout is
approximately 5
1
⁄
4
”
from left case wall
and 8
1
⁄
2
” from back case wall.
• Secondary Drain – Centerline of cutout is
approximately 6
1
⁄
2
” from left case wall
and 5
1
⁄
4
” from back case wall.
F Typical wall plug: 6”–12” above case
G Room air sensor kit: 10’ long
Outside wall
Flex duct may be used
for transitions only
Use rigid duct for
90° bends and tees
F
C
C
D
E
Platform
B
A
230/208 VAC
wall receptacle
or
conduit
for direct
connection
G