Marantz UD9004 - Manual (Page 29)

T
roubleshooting
Information
HDMI Control F
unction
Playback
Connections
Getting Started
Speciğcations
26
ENGLISH
HDMI Setup
Setting items Setting contents
SA-CD Audio Out
Set to output stereo/multi
area audio of Super Audio
CD to the HDMI terminal. On : Super Audio CD audio is output.
Off : Super Audio CD audio is not output.
The Super Audio CD audio signal is a 44.1 kHz/16-bit Linear PCM output.
HDMI Control
Can operate the unit in
conjunction with an HDMI
control support device. G Control H
Off • : Disable the HDMI control function.
HDMI1 On : • Link with the device connected to HDMI1.
HDMI2 On : • Link with the device connected to HDMI2.
G Power Off Control H
On • : Turns the UD9004’s power to standby through linkage to the TV.
Off : • Does not turn the UD9004's power to standby through linkage to
the TV.
For the HDMI control function to operate, it is necessary for the UD9004 •
or HDMI-compatible TV connected to the UD9004 to have an HDMI
connection.
Refer to “HDMI Control Function” (
• vpage 49) for more information
about the HDMI control function.
After the “HDMI Control” setting has been changed, always turn off the
•
power to the connected equipment and then turn it back on.
Setting items Setting contents
TV Aspect (Aspect ratio)
Set the screen type and
display mode of the TV. 16:9 Squeeze Auto : Output to a wide screen TV. For 4:3 video, display in
the center of the screen without changing the aspect ratio.
WIDE (16:9) : Output to a wide screen TV.
4:3 PS : Output to a 4:3 TV. For wide video, trim the left and right side of
the image and display in 4:3 aspect ratio. z1
4:3 LB : Output to a 4:3 TV. Display all of the wide video. z2
Component Resolution
Set the component output
resolution. 480/576i , 480/576P , 720P , 1080i ,
Source Direct : Output video using its source resolution. Convert the
1080p video source to 1080i.
Progressive Mode
Set an appropriate progressive
conversion mode for the
source video material. Auto : Detect the type of video material and automatically switch the
mode. Normally, this setting is used.
Video1 : Suitable for playing video material discs.
Video2 : Suitable for playing video material discs or 30-frame ğlm material
discs.
TV Active Area
Sets the horizontal display
range when the analog
video output resolution is
480i/576i. Full : Set when a home-use monitor is connected.
Normal : This setting is used when video synchronization is disturbed on
a professional-use monitor.
This is not available for HDMI output.
z1 : Depending on the video content, even though you set the 4:3 PS (Pan Scan), the content may be
output in 4:3 LB (Letter Box).
z2 : Only valid for content recorded in 480i/576i.
Set the video output signal according to the connected TV.
Video Setup Default settings are underlined.
Setup
Remote control operation
buttons
SET UP :
Displaying the menu
Cancel the menu
d f 0 1 :
Moves the cursor
(Up/Down/Left/Right)
ENTER :Decision the setting RETURN :Return to previous menu