Moog RKP-II - Manual (Page 51)

7 Operation Initial Pump Set-Up
© 2010 Moog GmbH User Manual RKP-II (CA53461-001; Version 2, January 2010) 43
7 Operation
Operation
7.1 Initial Pump Set-Up
Initial Pump Set-Up
For pumps in explosive areas, observe the supplementary documentation
as well:
Ö User Manual RKP II Explosion-proof
For any and all tasks to be performed on the pumps, appropriate personal
protective equipment should be worn.
Ö Chap. "2.2.4 Work Safety", Page 9
CAUTION Damage to the pump!
Setting up the pump for initial operation without the required
basic mechanical and hydraulic knowledge may result in
damage to the pump.
• The pump may only be set up initially by qualified
personnel.
DANGER Risk of injury and property damage as a result of blows or
impact!
Unexpected and uncontrolled movement of the machine /
equipment may lead to severe injury or property damage.
• Only trained personnel should be allowed to initially
set-up the pump.
• Have the equipment manufacturer or operator assure that
no uncontrolled signals are being transmitted to the pump.
• Have the equipment manufacturer or the operator assure
that a pump malfunction (e. g. piston jam caused by crud)
is recognized so that a malfunction of the axle / machine /
equipment can be prevented.
• Ascertain that all plug connections are wired and
allocated correctly.
• Make sure that all hydraulic ports are connected correctly.
• Make certain that the rotational direction of the drive
motor is correct.
• Check for correct drive shaft connection to the drive
motor.
• Have the equipment manufacturer or operator assure that
customer specific parameters were loaded correctly.
WARNING Risk of poisoning and injury!
Contact with the operating fluid can cause health problems,
such as injury to eyes, damage to the skin or inhalation
poisoning.
• Before initial set-up, check the lines and connection ports
for any damage.
• Adhere to the operating fluid manufacturer's safety
instructions.