Muratec F-98 - Manual (Page 68)

Beyond the basics
5 Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system may require. The num-
ber can be up to 40 characters in length:
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance number), press
to
scroll leftward or to scroll rightward.
Important: Do not press ENTER .
Note: If you make a mistake or want to erase characters entered in a previ-
ous setting, press CANCEL to erase leftward. Or, if you want to change
just one character in the number, press to move the cursor leftward,
or to move it rightward, to that character and press CANCEL to
erase it. Then re-enter until the number is just as you want it.
6 Now, while you can still see the fax number on the LCD , press COM - OPTIONS
five times and then press ENTER . The LCD shows:
7 Use the numeric keypad to enter the ITU - T sub-address for the box you want
to poll. Here, we’ve entered 123456:
8 Press ENTER . The LCD shows:
Note: If the password for the box is not entered, press ENTER and then skip
to step 10.
9 Use the numeric keypad to enter the appropriate ITU - T password for the box.
Here, we’ve entered 654321:
When finished, press ENTER .
10 If you want the transmission to begin immediately every time you press the
key, press
ENTER and skip to step 13.
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COM - OPTIONS , ENTER .
11 There’s a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1: Perform the command once at a certain time on a certain day of
the month. (For example, “Do this at 5:05
PM on the 30th.”)
To select this option, use the numeric keypad to enter the date
and time when the fax should perform the command:
Option 2: Perform the command at a certain time each day you press the
key. (For example, “Do this at 5:05
PM today.”)
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
12 Press ENTER , ENTER .
13 The LCD now displays the next programmable one-touch key.
If you do not want to enter or change any other key’s programming, press STOP
to return your machine to its usual standby mode.
If you do want to enter or change this key’s programming, go back to step 3.
If you want to enter or change another key’s programming, go back to step 2.
Delayed
Enter Time: 00/17:05
Delayed
Enter Time: 30/17:05
Enter Password
654321_
Enter Password
_
Enter Sub-Address
123456_
Enter Sub-Address
_
P4:Fax Number
9-5558422_
2.40