Muratec F-98 - Manual (Page 72)

Printing from your computer to your fax
With the RS -232 C interface installed, you can now use your fax machine to print let-
ters, reports, graphics and other business correspondence directly from your
computer.
Here’s how to use the printing feature:
1 Make sure your fax is connected to your computer (see page 2.43).
2 Computer: Use your application — for example, a word-processing program —
to send the document to your fax software, just as if you were actually going
to fax the document.
3 Fax machine: Make sure that you have stored your subscriber ID (see page
1.11) on your machine.
4 Computer: When the fax software asks you to enter a fax number for sending
the document, enter your subscriber
ID .
5 Computer: Instruct your fax software to transmit. The fax machine will begin
to print.
Sending/receiving faxes with your computer
You can also receive documents from another fax onto your computer, as well as
transmit documents from your computer to other faxes. As with scanning, the exact
procedure for sending/receiving will depend on how your computer’s particular fax
software works.
Note: Please consult your software’s operating instructions for more details.
Still, here are the basics:
1 Make sure your fax is connected to your computer (see page 2.43).
2 Computer: If your fax software allows it, turn off Error Correction Mode
(
ECM ).
3 Computer: Instruct your fax software to send or receive. The fax machine will
begin either transmitting or receiving.
“ AT ” commands
Note: This is a list of standard “ AT ” commands, which control your modem. For
more information, please consult the instructions for your fax software.
Beyond the basics
2.44
A none Call answer
D 0-9, *, # Dial number
P Pulse dial
T Tone dial
, Pause
E 0 Not echo command character E0
1 Echo command character
H 0 On Hook (Disconnect line)
1 Off Hook (Connect line)
M 0 Monitor speaker is always off M1
1 Monitor speaker is on until carrier is
detected
2 Monitor speaker is always on
P none Set pulse dial mode
T none Set tone dial mode
V 0 Short formed response code V1
1 Long formed response code
Z none Reset modem
&F none Initialize to factory setting
\Q 1 XON / XOFF flow control \Q2
2 RS / CS flow control
+ FCLASS ? none Indicate current service class
+ FCLASS =? none Indicate service class capability
+ FCLASS =n none Set service class
+ FRH =n none Receive HDLC frame (n=3:300bps)
+ FLO =n none XON / XOFF flow control (n=1) + FLO =2
none RS / CS flow control (n=2)
+ FRM =n none Facsimile receive message
(14400/12000/9600/7200/4800/2400bps)
+ FRS =n none Detect silence for n × 10ms
+ FTH =n none Transmit HDLC frame (n=3:300bps)
+ FTM =n none Facsimile transmit message
(14400/12000/9600/7200/4800/2400bps)
+ FTS =n none Wait for n × 10ms
Command Parameter Description Default value