Moxa Technologies DE-334 User Manual
Page 19
Configuring the Network
NPort Server Lite User’s Manual 3-3
3. Press
SEL
to select NETWORK SETTING, and then press
s twice. The LCD screen
should look like:
N E T W O R K
S E T T I N G
↑
I P A D D R R E S S
↓
4. Press
SEL
again, after which the default IP address will be displayed. Note that the first
digit of the IP address will be highlighted by a blinking cursor, indicating that it can be
edited:
I
P
A
D
D
R
R
E
S
S
↑
1
9
2
.
1
6
8
.
1
2
7
.
2
5
4
↓
The
SEL
button now acts as the right cursor, the
r button decreases the selected digit,
and the
s button increases the selected digit.
Keep in mind that there is no left cursor button. If you accidentally press
SEL
, moving
the blinking cursor to the right before inputting the correct digit, you will need to press
MENU
, and then start over at step 3.
You will notice that the displayed numbers are automatically limited to the range
required for IP addresses. For example, the first digit of each of the four numbers can
only be 0, 1, or 2.
5. Use the functions described above to enter the server’s IP address. After changing the
last digit, the blinking cursor will be all the way to the right, highlighting the last digit
of the number.
6. Press
SEL
to return to the screen shown in step 3. (To change the number, press
MENU
and then start over at step 3 above.) To accept the number, press
MENU
twice, after
which the LCD screen displays
S
A
V
E
C
H
A
N
G
E
?
N
O
↓
7. Press
SEL
to NOT save the setting, or press
r to change to the following screen:
S
A
V
E
C
H
A
N
G
E
?
Y
E
S
↓
8. Press
SEL
to save the setting. At this point the system will restart, and then return to the
default screen showing the server’s name, serial number, and IP address.