Minolta FAX2900 - Manual (Page 140)

7.2 Specifying the Machine Settings 7
7-3
Usi
ng the Util
it
y
M
ode
Ch
apte
r 7
7.2 Specifying the Machine Settings
From the “MACHINE SETTING” menu, various settings for the machine’s operating
environment can be specified. Refer to the following table for details on each
function.
No. Name Description
1 AUTO PANEL RESET Whether the Auto Panel Reset function is disable or the time (0.5 min,
1 min, 2 min, 3 min, 4 min, or 5 min) until the machine is reset after
finishing copying/printing or after performing the last operation can be
selected. If the Auto Panel Reset function is enabled, all functions are
automatically reset to their default settings.
• The factory default setting is 1 min.
2 ENERGY SAVE MODE If the machine performs no operations for a set length of time, it will
automatically enter the Energy Save mode. The length of time until the
machine enters Energy Save mode can be set between 1 min and
240 min (in 1 min increments).
• The factory default setting is 15 min.
3 DENSITY The scanning density when using the Auto Document Feeder can be
adjusted.
Mode 1: For printing lighter copies of dark documents to avoid
darkening of copies.
Mode 2: For printing copies with same density as documents.
• The factory default setting is “Mode 1”.
4 PRINT DENSITY The copy/print density can be adjusted to one of six levels between
–3 and +3. With the normal print density at 0, choose a smaller number
for a lighter print or choose a higher number for a darker print.
• The factory default setting is “0” (Normal).
5 LCD CONTRAST The brightness of the display can be set to one of four levels between
–1 and +2.
• The factory default setting is “0” (Normal).
6 BUZZER VOLUME This function can be used to set the volume of alarms and the beep
sounded when a key is pressed.
• The manufacturer’s default setting is “LOW”.
7 INITIAL MODE This function can be used to set the mode (Copy mode or Fax mode)
that the machine starts up in or returns to after the Control Panel is
reset.
• The manufacturer’s default setting is “COPY”.