Minolta FAX2900 - Manual (Page 237)

8 8.8 What Does Each Message Mean?
8-22
Wh
en a
Me
ss
ag
e A
ppea
rs
Chap
ter
8
8.8 What Does Each Message Mean?
Message Cause Action
*REMOVE PAPER IN BYPASS
TRAY* Paper is loaded in the Bypass
Tray. Remove the paper from the
Bypass Tray.
FRONT COVER OPEN
CLOSE FRONT COVER
The Front Cover of the main
unit is open or not securely
closed. Securely close the Front Cover.
DOC.FEED COVER OPEN
CLOSE DOC.FEED COVER
The Document Feeder Cover is
open. Securely close the Document
Feeder Cover.
MEMORY FULL
PRESS ANY KEY
The size of the data for the
scanned document has
exceeded the capacity of the
memory. Press the [Panel Reset] key, or
turn the machine off, then on
again. (The scanned data
should be cleared from the
memory.)
MACHINE TROUBLE
SERVICE CALL (C####)
Some problem occurred in the
machine. Turn the machine off, then on
again. If the error is still
displayed, contact your service
representative.
FUSER COVER OPEN
CLOSE FUSER COVER
The Fuser Cover of the main
unit is open or not securely
closed. Securely close the Fuser
Cover.
PAPER JAM
OPEN FRONT COVER
A paper misfeed occurred. Perform the misfeed-clearing
procedure. (p. 8-16)
All misfed paper was not
removed from the main unit.
The Fuser Cover of the main
unit is open or not securely
closed. Close the Fuser Cover, then
open and close the Front
Cover.
NO SUITABLE PAPER
LOAD PAPER (LT)
In Fax mode, plain paper of a
size other than Letter, Legal or
A4 is loaded into the paper tray. Load plain paper of the
appropriate size into Tray1 or
the optional Tray2.
INCORRECT T/C TYPE
CHANGE T/C
Incorrect type of Toner
Cartridge is installed. Install the correct type of Toner
Cartridge. (p. 8-5)
Toner Cartridge is not installed. Install the Toner Cartridge.
(p. 8-6)
LINE PROBLEM
CHECK LINE
• The telephone dialing
system or telephone wiring
system are not set correctly.
• The telephone cable is not
attached correctly.
• Check the telephone dialing
system or telephone wiring
system and use the
appropriate Utility mode
function to make the correct
settings.
• Correctly connect the
telephone cable.
(Flashing alternately)