Multi-Tech Systems MT3334HD8 - Manual (Page 21)

3 AT Commands
CommPlete Communications Server 15
Error Correction & &E0 Non-error correction mode 31
Data Compression &E1 Auto-reliable mode
&E2 Reliable mode
&E14 Data compression disabled
&E15 Data compression enabled
#L V.42 error correction modes
$E V.42 error correction at 300 bps
$A Auto-reliable buffering
$F Auto-reliable fallback character enable
$R Retransmit count
Speed Controls $BA Baud adjust 33
$MB Modem baud rate
$SB Serial port baud rate
Immediate Action A/ Repeat last command 35
I Inquire product code
L5 List current operating parameters
L6 List S-register values
L7 List current operating parameters
L8 List online diagnostics
&RN Rate renegotiation
&RR Retrain
Flow Control &BS Maximum reliable block size 36
$EB Asynchronous word length (10/11-bit)
&E3 Flow control disabled
&E4 Hardware flow control
&E5 XON/XOFF flow control
&E6 XON/XOFF no pass-through
&E7 XON/XOFF pass-through
&E8 Hewlett Packard ENQ/ACK pacing off
&E9 Hewlett Packard ENQ/ACK pacing on
&E10 Non-error correction mode flow control off
&E11 Non-error correction mode flow control on
&E12 Pacing off
&E13 Pacing on
#X Number of XOFF characters sent
Escape +++AT<CR> Default in-band escape sequence 39
Sequences <BREAK>AT<CR> Alternate out-of-band escape sequence
%E Escape sequence selection
A Force answer mode
O Go back online
Remote %%%AT<CR> Remote configuration escape sequence 40
Configuration #I Change login password
#S Change setup password
Line Probes %DP Read line probe data 41
%DF Format line probe data
&RP Immediate line probe
L9 Display signal strength
L10 Display signal to noise ratio
L11 Display noise strength
Diagnostics &T Respond to remote digital loopback signal 42
U Loopback test modes