Changing the passwords, Changing the remote escape character – Multi-Tech Systems MT3334HD8 User Manual
Page 92
MT3334HD8 User Guide
86
CommPlete Communications Server
Changing the Passwords
1. Establish a remote configuration link with the remote modem as described above.
2. Type AT#IMULTI-TECH (or AT#I
xxxxxx
if you have replaced the MULTI-TECH password with
xxxxxx
) and press E
NTER
. The modem responds with OK
if the login password is correct, and
ERROR
if it is wrong.
3. Type AT#SMODEMSETUP (or AT#S
yyyyyy
if you have replaced the MODEMSETUP password
with
yyyyyy
) and press E
NTER
. The modem responds with OK
if the setup password is correct, and
ERROR
if it is wrong.
4.
To change the login password, type AT#I=
xxxxxx
, where
xxxxxx
stands for the password, and
press E
NTER
. The password may include any keyboard characters, but must be six to ten characters long.
The modem responds with
OK
.
5. To change the setup password, type AT#S=
yyyyyy
, where
yyyyyy
stands for the password, and
press E
NTER
. The password may include any keyboard characters, but must be six to ten characters
long. The modem responds with
OK
.
6. The new passwords are saved automatically. You may now either enter more AT commands or exit
remote configuration with ATO<CR>. The next time you remotely configure the modem you must
use the new setup password.
Note:
Passwords are case sensitive. The next time you enter the password, it must be in the same case as
you set it up.
Changing the Remote Escape Character
To increase security, you may wish to change the remote modem’s remote configuration escape character.
The remote configuration escape character is stored in register S13. The factory default is 37, which is the
ASCII code for the percent character (%). Setting S13
to 0 (zero) will disable remote configuration
entirely—but if you do this remotely, you won’t be able to change it back remotely!
1. Establish a remote configuration link with the remote modem as described above.
2. Type ATS13=
n
, where
n
is the ASCII code for the new remote configuration escape character, then
press E
NTER
.
3. Save the new value by typing AT&W and pressing E
NTER
.
4. Type ATO<CR>, then 1, to exit remote configuration.