Multi-Tech Systems MT3334HD8 - Manual (Page 88)

MT3334HD8 User Guide
82 CommPlete Communications Server
Command Values Description
&SFn n = 0 or 1 DSR/CD Interaction Control
*** &SF0 Select DSR to follow CD.
&SF1 Select DSR to be independent.
$SBn n = speed Serial Port Baud Rate
Baud Adjust $SB300 Select 300 bps at serial port.
($BA) must $SB1200 Select 1200 bps at serial port.
be off. $SB2400 Select 2400 bps at serial port.
$SB4800 Select 4800 bps at serial port.
$SB9600 Select 9600 bps at serial port.
$SB12000 Select 12,000 bps at serial port.
$SB19200 Select 19,200 bps at serial port.
$SB38400 Select 38,400 bps at serial port.
$SB57600 Select 57,600 bps at serial port.
*** $SB115200 Select 115,200 bps at serial port.
#Sy y = password Enter Setup Password
Password is case sensitive.
#S=y y = password Store Setup Password
Password must be 6–10 characters long, and may
consist of any keyboard characters.
T In dialing
command Tone-Dial
Modem tone-dials numbers following the T.
&Tn n = 4 or 5 Respond to Remote Digital Loopback Signal
&T4 Enable response to remote digital loopback
signal.
*** &T5 Disable response to remote digital loopback
signal.
$Tn n = 0 or 1 Calling Tone
$T0
Enable calling tone.
*** $T1 Disable calling tone.
#Tn n = 0 or 1 Trellis-Coded Modulation
#T0
Disable trellis-coded modulation.
*** #T1 Enable trellis-coded modulation.
Un n = 0–3 Loopback Test Modes
U0
Enable analog loop originate mode.
U1 Enable analog loop answer mode.
U2 Enable remote digital loopback mode.
U3 Enable local digital loopback mode.
Vn n = 0 or 1 Result Codes (Verbose/Terse)
V0
Result codes sent as digits (terse response).
*** V1 Result codes sent as words (verbose
response).