Miele NOVOTRONIC T 7644 C - Manual (Page 16)

F Starting the program
The Start/Stop button flashes during
program selection. This means that a
program can be started.
^ Press the Start/Stop button.
The Start/Stop button lights.
Drying appears in the display and the
time remaining is counted down.
Before the end of a program
After the drying phase finished a
cooldown phase follows.
The following programs have no
cooldown phase: Woolens, Smoothing.
G End of program - Remove laundry
0 and End appear in the display to
indicate the program end. The buzzer
sounds at intervals (when selected).
After the program end the drum rotates
reversible in intervals if clothes are not
removed (Anti-crease action). This
helps to prevent creasing for up to 2
hours.
^ Press the Door button.
^ Open the door.
^ Remove the laundry.
Check that the drum is empty.
Laundry left behind may be
damaged if dried again.
To save energy, the drum light turns off
after a few minutes when the dryer is
not operating and the door is open.
^ To shut it off, press the On/Off button.
^ Clean the lint filter and lint screens.
^ Close the door.
^ Empty the condensed water
container (if the condensed water is
not drained off externally).
^ The condenser should be checked at
intervals and cleaned as necessary
(See the section on "Dryer Care").
Proper drying
16