Miele NOVOTRONIC T 7644 C - Manual (Page 49)

Extending cooldown time
You can individually lengthen the
cooldown phase the occurs before
the end of a program. Fabrics will be
more completely cooled down.
Cooldown time
– can be extended by two stages.
– it does not function for Smoothing
programme.
For programming and saving in
memory, follow steps
A to E.
The programmable function is
programmed using the buttons.
Precondition:
– The dryer is switched off.
– The door is closed.
A Press Start/Stop and keep it pressed
it during steps
B-C.
B Press the I-On/0-Off button in.
Wait until the Start/Stop button lights up
continuously . . .
C . . . then release the Start/Stop
button.
D Press the Gentle button three times.
– The Gentle indicator light flashes
briefly seven times.
–
P and 0 flash alternatingly in the
display (default setting).
The number appearing alternatingly
with
P means:
0 Default setting
I Five minutes longer cooldown time
(Express indicator light will flash
once)
2 Ten minutes longer cooldown time
(Express indicator light will also flash
twice)
E Pressing the Start/Stop button
switches from one to the other.
F Using the I-On/0-Off button, switch
the dryer off.
The programming is now stored in
memory. You can change it again at
any time.
Programmable functions
49