Miele NOVOTRONIC T 7644 C - Manual (Page 40)

Draining condensed water
externally
General
When drying is in progress, the
condensed water is pumped into the
condensed water container through the
drain hose at the back of the dryer.
You can also drain it off externally
through the drain hose - you will no
longer need to empty the condensed
water container.
Hose length . . . . . . . . . . . . . . . . 1.50 m
Max. delivery height . . . . . . . . . . 1.50 m
Max. delivery length . . . . . . . . . . 4.00 m
,
Under special kinds of
connection conditions, this dryer
must be fitted with a non-return
valve (see following pages).
The following optional accessories are
available:
– an extension hose.
– a non-return valve kit for conversion
to an external water outlet
(includes an extension hose).
Max. delivery head with non-return
valve fitted: 1.00 m
Arranging the drain hose
,
Do not pull on the drain hose,
stretch it or kink it,
as it could get damaged!
^ There will be a small amount of
residual water in the drain hose.
Have a container ready to collect it.
^ Pull the drain hose off its connection.
^ Allow any residual water to run into
the container.
^ Unwind the hose from its coil and pull
it carefully out of the holders.
^ Guide the hose to the right or left side
of the dryer, as necessary.
Leave the hose in the central holder to
prevent it from being inadvertently
kinked.
Installation and connection
40