Miele NOVOTRONIC T 7644 C - Manual (Page 52)

Changing water conductivity
setting
,
This programmable function
should be adjusted only when
residual water content is erroneously
determined owing to the extreme
softness of the water.
Important condition
The water in which fabrics are washed
may be extremely soft with a
conductivity value less than 150 μS/cm.
Drinking water conductivity can be
ascertained from your local water
supplier.
Activate this programmable function
only if the above-mentioned
condition applies.
Otherwise the drying result will be
unsatisfactory.
For programming and saving in
memory, follow steps
A to E.
The function is programmed using the
buttons.
Precondition:
– The dryer is switched off.
– The door is closed.
A Press Start/Stop and keep it pressed
it during steps
B-C.
B Press the I-On/0-Off button in.
Wait until the Start/Stop button lights up
continuously . . .
C . . . then release the Start/Stop
button.
D Press the Gentle button six times.
– The Gentle indicator light flashes
once slowly and twice briefly.
–
P and 0 flash alternatingly in the
display (default setting).
The number appearing alternatingly
with
P means:
0 Default setting
I Lower conductivity setting
(Express indicator light also flashes)
E Pressing the Start/Stop button
switches from one to the other.
F Using the I-On/0-Off button, switch
the dryer off.
The programming is now stored in
memory. You can change it again at
any time.
Programmable functions
52