Monessen Hearth Direct Vent Gas Fireplace KHLDV SERIES - Manual (Page 31)

73D0024 31
LOG PLACEMENT
1. Place the rear log over the grate toward the back by positioning the holes over the large pins located at the right and left.
When the log is in place, the back surface of the log will come in contact with the light trapezoid deflector.
2. Place the log over the pilot by holding the log with the wide end toward the back and the branch toward the front and
left. Set the log by having the protrusion on the bottom of the log rest to the left side of the grate bar and behind the pilot
shield. Also set the notch located at the bottom of the left branch over the second right tong on the grate. Make sure that
the log is positioned properly so it is not rocking. NOTE: When the log is in place, it should not touch the pilot but
will be resting over the pilot shield.
FINAL INSTALLATION
Burner Grate Assembly Step 1
Step 2 Step 3
3. Place the left front log in place by setting it over the left side of the rear log (match protrusion to indentation), the hearth
brick and over the left tong on the grate. Match the notch at the bottom of the branch with the tong on the grate.
4. Place the middle log over the two burners by setting the flat surface over the burner and matching the indentation located
underneath the branch over the protrusion located at V-branch on the left front log placed in step #3. Rotate the right
end of the log clockwise until it comes in contact with the reverse bend on the bracket located between the front and
rear burner.